Post by gbodyfan on Jun 11, 2007 19:14:47 GMT -5
Ok, Here it is... 1994 SBC powered Mustang for sale.
-AJE tubular K member for SBC.
-AJE tubular X member for powerglide.
-8.8 Rear...4.30 motorsports gear, full spool, c-clip elims and 31 spline moser axles.
-Adjustable upper control arms and southside lower lift bars.
-Draglites on all four corners w/ new front runners and hoosier 28x10 slicks.
-8 gallon fuel cell and optima red top battery in trunk.
-1/2 inch fuel line from rear to front w/ 110 gph mech fuel pump.
-6 point rollbar, glass seat w/ slider and simpson 5 pt harness.
-Bills built glide w/ pro tree brake, 1.76 ratio, alum deep pan.
-Chance 8 inch 5000 stall brake converter.
-Dedenbear Co2 crossover delay box, dedenbear shift timer.
-TCI lightning stick shifter w/ shift solenoid.
-All gauges and shift lite included.
-Moroso adj trans brake button.
-B & M line lock.
-New front pads, rotors, struts and coil springs. Also new shoes on the rear. (By the way, it is a 5 lug all the way around).
-MSD 6 AL box and newer HEI dist w/ super coil.
-Electric water pump drive, electric fan, HD trans cooler and aluminum radiator.
-358 SBC w/ Moroso 7 qt deep oil pan, .040 flattop pistons, vortec heads w/ screw in 7/16 studs, guide plates and Comp pro magnum full roller rockers. Super victor vortec intake w/ 1 inch carb spacer and 800 Holley DP.
-I have a 4 inch cowl to go with it but is not installed on hood yet.
-Motor is just shy of 9.5 to 1 compression. Runs great on pump gas since the vortecs don't require a lot of timing.
-40 series Flowmaster exhaust w/ X pipe.
-Car has seen 11.60's in good air. A little spray would get it into the 10's!
*This is a fun car to drive, but I would like to concentrate on my other vehicle at this time.
Im asking $6000 for it. Sure it sounds like a lot, but it is a TURNKEY racecar!!!
Post on here if interested or call my cell...316-737-4031. I am located in Wichita, KS. Thanks!!
-AJE tubular K member for SBC.
-AJE tubular X member for powerglide.
-8.8 Rear...4.30 motorsports gear, full spool, c-clip elims and 31 spline moser axles.
-Adjustable upper control arms and southside lower lift bars.
-Draglites on all four corners w/ new front runners and hoosier 28x10 slicks.
-8 gallon fuel cell and optima red top battery in trunk.
-1/2 inch fuel line from rear to front w/ 110 gph mech fuel pump.
-6 point rollbar, glass seat w/ slider and simpson 5 pt harness.
-Bills built glide w/ pro tree brake, 1.76 ratio, alum deep pan.
-Chance 8 inch 5000 stall brake converter.
-Dedenbear Co2 crossover delay box, dedenbear shift timer.
-TCI lightning stick shifter w/ shift solenoid.
-All gauges and shift lite included.
-Moroso adj trans brake button.
-B & M line lock.
-New front pads, rotors, struts and coil springs. Also new shoes on the rear. (By the way, it is a 5 lug all the way around).
-MSD 6 AL box and newer HEI dist w/ super coil.
-Electric water pump drive, electric fan, HD trans cooler and aluminum radiator.
-358 SBC w/ Moroso 7 qt deep oil pan, .040 flattop pistons, vortec heads w/ screw in 7/16 studs, guide plates and Comp pro magnum full roller rockers. Super victor vortec intake w/ 1 inch carb spacer and 800 Holley DP.
-I have a 4 inch cowl to go with it but is not installed on hood yet.
-Motor is just shy of 9.5 to 1 compression. Runs great on pump gas since the vortecs don't require a lot of timing.
-40 series Flowmaster exhaust w/ X pipe.
-Car has seen 11.60's in good air. A little spray would get it into the 10's!
*This is a fun car to drive, but I would like to concentrate on my other vehicle at this time.
Im asking $6000 for it. Sure it sounds like a lot, but it is a TURNKEY racecar!!!
Post on here if interested or call my cell...316-737-4031. I am located in Wichita, KS. Thanks!!
