Front engine dragster

[dalejohnson]

200" FED slingshot dragsters frame, just finished this spring ( 2013). It will cert to 6.00 seconds ( 2.4B), it has a short aluminum body, mark Williams classic drop front axle, wire wheels,& torsion bar front suspension. ( It looks like the late 1960's. I will e mail you pictures if you wish) 460 ford with crower 484/509 lift, 211/218 .050 cam, hyd. lifters, Forged I beams with cap screws, flat top hyper pistons, ported factory D-3 heads, holly 750 by classic motor sports for e 85 fuel (set up with pro form body & dominator bowls & alky stainless base plate, flows around 830 cfm), torker 2 manifold, msd ignition & planetary starter. The radiator tucked in the frame rails so you can't see it. Also a ptc 3800 stall converter, jw bell, sfi flywheel, Powerglide with 5 alto red clutches, rebuilt 1.76 planet, & the transmission totally gone through, along with a 4130 input shaft. A Mark Williams ford 9" gun drilled 35 spline rear axle with 3.70 large pinion pro gear, dana support, Mark williams nodular case (the axle set up is good to 2500 hp) & dual Willwood calipers on each rotor. I built it for a turbocharger, but life has changed. As it is I have ran it a total of 20 passes, & it is dead straight, and very reliable. it weighs 1680 with that big all iron motor (no driver included in the weight), and runs 10.23@129 in 3500 ft of air. The fuel is $3.20 a gallon too. Built to last a long time, all I need to do is check the oil & add fuel. 12,000 turn key, or 10,000 as a roller ( everything but the motor), I have a car hauler trailer for it and about 45 gallons of fuel. The sfi-15 suit ( 5'10" & 180# fits great), shoes, gloves, helmet, & neck collar are available for $600. Dale Johnson Coldwater KS. Will consider trades for a honda, toyota, 1964-68 mustang or a 1966-67 fairlane.
[e-mail] or [e-mail], evening phone [phone]
a picture can be viewed here www.460ford.com/forum/showthread.php?t=172977

[dalejohnson]

Sold